Because there is such a big jewelry investment, earring tray stands to reason that our jewelry storage sites should be customized for our jewelry. The easiest way to one of the wooden jewelry box is bought, has been cut to the width and length of the timber.

Preparation
One to two 8-inch side of the block and two 11-inch front and behind the desk jewelry box. Next, place the two felt measuring 3.5 inches, 8 inches, and accompanied by two half 11-inch think plywood next.

2 application of spray glue each piece of felt and wood. Let dry, spray another coat. Second, insist on the carpet of wood, to straighten out all the wrinkles. Set these aside.

3 Set the center of a 11 inches, together with supporting two separate feel on the table. Apply spray adhesive wood and each one felt half of the side - just enough to adhere to the feeling side of the timber. Ready to apply for that timber, to straighten out all the wrinkles.

4 Turn all the work, apply to the rest of some of the adhesive, and in accordance with the instructions on the can, let them dry. Ready to apply for a carpet of wood to straighten out all the wrinkles.

5 ¼ inch on the table, with the bottom of the match feeling. Some of the adhesive application, whether it is wood and feeling, so that they dry and can be described. Ready, will feel the wood, to straighten out all the wrinkles.

6 cut ¼ inch of the perimeter of the bottom of the X-ACTO knife about half an inch. 8 inches at both ends of the same. This will allow wood in contact with wood and hide think the jewelry box.

Assembly
1, placed on the table, side by side are two 8-inch side. And then measuring three inches and a half from one end, and make a mark. Carpenter, Mark Plaza, and the mapping of the two cross-plywood. Another sign of ½ inch further, a carpenter's square, mark and draw two cross-plywood.

Drill pilot holes at both ends of line and ½ inches. Two 11 in. pieces of the front and the back of the jewelry box at both ends of the artist's brush, apply a small amount of glue. You will know them, because they feel that only one party.

3 two 8 inches, 11 inches, and to ensure that they and ¾-inch brads. Next, jewellery box glue brush to 11 inches of both ends of the film, is the center of the jewelry box. Set in place to ensure that ¾-inch brads.

Open the jewelry box, so that all exposed edges, do not feel for them. Coated with the edge of the brush some glue on the bottom of the jewelry box, carefully and ensure that it is ¾ inch brads.

5 to open the jewelry box on the right. Applies to glue the two separated by the edge of the brush, and set them in the jewelry box, you want them to. The top to allow the glue to set up additional jewelry box, at least three hours before.

Install the piano hinge at the top of the back of the edge. Placed on the box top, and put it up so that you are looking for the piano hinge. wooden box fixed piano hinge to the bottom of the short-term brads jewelry box.